7/8/2023 0 Comments Raceflight revolt zadig driver' checked and the whole process starts over when I cycle the USB plug again (two Revolution 'Other devices' with no drivers) Then I Uninstall both the drivers with 'Delete drivers. If I assign (using Zadig) the 'USB Serial (CDC)' driver to EITHER ONE or BOTH (see attached image), I still can't connect in BFC as you can see. In Zadig 2.2.689, they show up as Revolution (Interface 0) and Revolution (Interface 1). ![]() Both have no driver associated with them.īecause there are no COM port drivers for them, BFC does not connect, but the firmware is running because of the series of LED flashes I see when I plug it in. ![]() When I plug the F4 REVO ACRO into USB, device manger sees it and gives me TWO 'Other devices' called 'Revolution'. I have now flashed BF 3.0.0 onto my F4 REVO ACRO. The last firmware on this F4 REVO ACRO was Raceflight BB235 which connected fine in RFC on a VCP com port that appeared when the FC was plugged in.
0 Comments
Leave a Reply. |